Skip to main content

Mace Engineering Group

Mace Engineering Group

Community
Submit a request
Sign in

Sign in
Community
Submit a request

Mace Engineering Group
GENERAL ENQUIRIES
General Enquiries

Articles in this section

Do you have a triple pod version of the gauge pod to suit Ford Falcon BA BF XR6 8
Is the 6-SPEED BILLET T56 SHORT SHIFTER HOLDEN LS1 L76 L98 5.7L 6.0L V8 squential gear shift or standard shift?
Can I Paint My Manifold Insulator/Plenums Spacer?
I purchased a 70mm throttle body from Mace around November 2008 for my VP 5.0L Commodore. Since the install back in 2008, I have noticed that the gear changes have all changed and the car will not drop back easily into lower gears when floored. I just as
I have a series 1 VN motor in which I am looking to upgrade the camshaft to a stage three flanged cam would I need new bearings?
Are the Mace superchargers for VS V6 suitable for a stock engine?
Are you able to replace the rotor plate bearings and seals in COLD AIR INTAKE 25MM INSULATOR SUPERCHARGED V6 L67 on a M90?
As Mace recommends Standard rockers with the stage 2 COMP cam, would I need to space out the rocker covers to allow for room? I’ll need new rockers to suit the rollers yes?
Can a L67 SUPERCHARGED V6 vehiclebe driven to the tuner after installation of an AIR TO AIR INTERCOOLER PLATE?
Can I put 15 psi pulley onto my engine without any problems?

See more

Do you supply 4:11 diffs?

Michael

August 15, 2023 09:39
Updated

Yes, we do.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Related articles

Does die grinding the inlet manifold to 70mm or matching the port to throttle body helps or just bolting on it is enough to gain high power or acceleration for Holden VN-VY?

Comments

0 comments

Please sign in to leave a comment.

Mace Engineering Group

Powered by Zendesk