Skip to main content

Mace Engineering Group

Mace Engineering Group

Community
Submit a request
Sign in

Sign in
Community
Submit a request

Mace Engineering Group
GENERAL ENQUIRIES
General Enquiries

Articles in this section

Do you have a triple pod version of the gauge pod to suit Ford Falcon BA BF XR6 8
Is the 6-SPEED BILLET T56 SHORT SHIFTER HOLDEN LS1 L76 L98 5.7L 6.0L V8 squential gear shift or standard shift?
Can I Paint My Manifold Insulator/Plenums Spacer?
I purchased a 70mm throttle body from Mace around November 2008 for my VP 5.0L Commodore. Since the install back in 2008, I have noticed that the gear changes have all changed and the car will not drop back easily into lower gears when floored. I just as
I have a series 1 VN motor in which I am looking to upgrade the camshaft to a stage three flanged cam would I need new bearings?
Are the Mace superchargers for VS V6 suitable for a stock engine?
Are you able to replace the rotor plate bearings and seals in COLD AIR INTAKE 25MM INSULATOR SUPERCHARGED V6 L67 on a M90?
As Mace recommends Standard rockers with the stage 2 COMP cam, would I need to space out the rocker covers to allow for room? I’ll need new rockers to suit the rollers yes?
Can a L67 SUPERCHARGED V6 vehiclebe driven to the tuner after installation of an AIR TO AIR INTERCOOLER PLATE?
Can I put 15 psi pulley onto my engine without any problems?

See more

When converting an Ecotec to L67, will the Ecotec headers fit L67?

Michael

July 04, 2023 07:47
Updated

Yes, they will.

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Related articles

General conversion requirements and tuning info
What gaskets and seals are included in the MACE FULL ENGINE GASKET KIT TO SUIT HOLDEN L67 SUPERCHARGED 3.8L V6
Fitting VS-VY L67 into VS commodore
Would you say the L67 conversion is worthwhile?
Bank Details (westpac)

Comments

0 comments

Please sign in to leave a comment.

Mace Engineering Group

Powered by Zendesk