General Enquiries
- Do the air filters in Mace's cold air intake to suite Holden VZ V6 cope with the heat from the engine or will I need to get a better air filter?
- Do the air filters in your MACE Cold air intake kits cope with the heat from the engine or will i need to get a better air filter?
- Do the Aluminum rocker covers come with new rocker cover gaskets? And do they fit a VS statesman v6 l67?
- Do the engine valve rocker arms for Holden ALLOYTEC SIDI LY7 LE0 LU1 LF1 LFW LLT LFX 3.0 3.2L 3.6L V6 suit 2014 V6 Camaro?
- Do the factory supercharged V6’s run off the one belt instead of two?
- Do the MACE PERFORMANCE CAMS TO SUIT Holden Alloytec LY7 LE0 3.6L V6 work with the dual fuel?
- Do the o-rings come as a set of 2 for $15? Do I need 2 o-rings?
- Do the POLISHED ALUMINIUM ROCKER COVERS TO SUIT ECOTEC
- Do the POLISHED ALUMINIUM ROCKER COVERS to suit my VX V6 ecotec come with rubber gaskets/o rings?
- Do the rear coilovers just replace the shock with XYZ PERFORMANCE COILOVER HOLDEN COMMODORE HSV SEDAN WAGON UTE VG VQ VP VB VN VR VU VT VX VY VZ VE VF?
- Do the rockers require a tune?
- Do the rubber seals of the inlet manifold gasket to suit ECOTEC L67 SUPERCHARGED V6 have the locking pins on them?
- Do the tappet covers come with gaskets and oil cap?
- Do these require a different control module or will these work properly/safely with standard equipment?
- Do u have a cam that would fit with aftermarket 1.95 roller rockers?
- Do u recommend to block the silence ports in L67 Supercharger porting?
- Do you do a post out tune for a v6 t5 vs commodore with a stage comp cam?
- Do you do and ECU for V6 Ecotec putting it into a boat?
- Do you do installation of the supercharger kits? And how much would it cost to install?
- Do you do the 3.4 inch pulley 10 psi, in the 6 ribbed belt set up. Or can the 8 ribbed 3.4 inch pulley go on with the 6 ribbed standard pulley set up?
- Do you fit the "PERFORMANCE 25MM PLENUM SPACER Holden V6 VS-VY"as the glue describes? Or do I just put it on and tighten it back up? The glue says I need to put some on then finger tight and let dry for 1 hour ten tighten more.
- Do you guys do a Twin Throttle Body on the one side I thought I saw one on here at some stage?
- Do you guys do a Twin Throttle Body on the one side? I thought I saw one on here at some stage.
- Do you guys havea 25mm manifold insulator for the LLT engine on your website?What procedure must be fwollowed to ensurereasonable clearance under the bonnet?
- Do you guys offer stickers which I want to put on my vehicle as a means of promoting MACE products. If yes, how do I get some?
- Do you guys sell a quad core radiator to suit a VZ Commodore V6?
- Do you guys sell arp rod bolts for the L32 powder coated rods?
- Do you have a Cold Air Intake kit for a ed Falcon with V8 5.0?
- Do you have a Cold Air Intake kit for a ED Falcon with V8 5.0L?
- Do you have a cold air intake to fit a 2003 VY Clubsport? Does it come as a kit with hose clamps etc?