V6
- Are the GM US spec l67 long motors which are available from the US compatible with Holden l67s?
- Can I Use The 'Comp Cam Re-Usable Rocker Bolts' On A standard Engine With Standard/High Ratio Rockers As Replacements For The Factory Items?
- Do you supply individual head studs and nuts for my 3.8 litre V6?
- 3. Extreme Build
- 3. L67 3.8L Supercharged V6 Intercooler Package
- Are Comp Cams Designed To Be Lumpy?
- At Which Part Of The Rev Range Do The Cams Make The Most Power?
- Can I Bolt An M90 Supercharger To My Ecotec?
- Can I Run An 11PSI (3.3") Pulley On A Standard Engine?
- Can The Standard Motor Handle The Increased Power?
- Can You Tune To Suit Intercooling?
- Can Your Aluminium Rocker Covers Be Drilled And Have Fittings Welded On Without Damage For An Oil Catch Can?
- Do I Need Injector Rail Extenders To Suit The 6mm Supercharger Insulator For My M90? How Do I Install This?
- Do I Need To Degree My New Cam In?
- Do I Need To Replace Or Upgrade My Valve Springs?
- Do I Need To Upgrade The Pushrods With The High Ratio Rockers?
- Do The Aluminium Rocker Covers Come With New Gaskets?
- Do the Cams you supply affect idle?
- Do The Crow Cam Hydraulic Lifters Need To Be Primed With Oil Prior To Installation?
- Do You Supply Race Balancers for Ecotecs (non-L67)?
- Do You Supply Tunes for Stroked Engines?
- Does The Oil Pump Kit Come With A Higher Oil Pressure Relief Spring?
- How Do The Cams Affect Fuel Economy?
- How Hard Is It To Fit Cams?
- How Much Extra Capacity Does The Stroker Kit Provide
- I'm Looking For A Lumpy Idle, What Cam & Chip Package Do You Recommend?
- If I Were To Install The Stage 2 Comp Cam With 1.9:1 Ratio Rockers Would I Have Any Problems With Lift Clearance Or Would I Have To Revert To A Lower Ratio?
- What Can I Do To Get More Power Out Of My Supercharged V6?
- What Components Should I Upgrade When Fitting A Cam To My 3.8 Litre V6?
- What do I need to take into consideration when fitting a stroker kit?