Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
Would Mace have a replacement for my L67 W2A intercooler plate CORE, I am looking for a good core replacement?
We do. Which intercooler plate do you currently have?
-
Would Mace have something similar to COLD AIR INTAKE TO SUIT HOLDEN VT-VY LS1 V8 MAFless for a VH Commodore with a LS1 conversion?
We would, as shown in the link below. However, we would need to supply you with a VB-VL lid instead of a VN-VP one as pictured: http://www.maceengineering.com.au/epages/shop.sf/en_AU/?ObjectID=235...
-
Would Mace know how to or be able to install an oil temperature sensor in my LFX engine?
Ideally, you would want to install an oil temp sensor directly in the sump, however, this would not be easy to do. An easier option would be to plumb in a T piece between the engine block and facto...
-
Would Mace know where I can get a fresh motor from with a Budget of $3500?
Best to contact our engine builder John Hamilton. I can't recommend him enough John@gatewaybbs.com.au Mobile Phone 0409 806 534
-
Would Mace offer anything in the ways of a SS Growler Intake kit to suit a V6?
To give you an idea as to some of the cold air intakes that we have available, please refer to the link below: http://www.maceengineering.com.au/epages/shop.sf/en_AU/?ObjectPath=/Shops/mace/Catego...
-
Would Mace recommend using the 25mm or the 12mm intake manifold insulator with a twin throttle body set up?
Long story short, if you were sticking with bolt on mods then I would stick with the 25mm manifold insulator. Otherwise if you had a cam and were aiming to make strong mid to top end power gains, I...
-
Would Mace's 25mm Manifold Insulator for Alloytec VZ-VE cause fitting issues with a factory strut brace?
From experience our 25mm manifold insulator kit installed on either a VZ or VE Alloytec won't have any clearance issues. In saying this though, it wouldn't be a bad idea to take a couple of quick m...
-
Would SV6 VE VF ORSSOM OTR cold air intake SIDI LFX LLT 3.6 3.0 V6 suit 2012 VE dedicated gas?
Yes, it will, there shouldn't be any issue.
-
Would the 25mm fit in the Adventra?
They would fit in Adventra, assuming it doesn't run a strut brace.
-
Would the 25mm manifold insulators fit my vz v6 or will it hit bonnet?
It will fit under the bonnet without any modification. For further information about this product please check out the link below: http://www.maceengineering.com.au/epages/shop.sf/en_AU/?ObjectPat...