Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
Would be able to recommend someone who makes fuel rails for the L67 engine? I found a pile of LS1 billet rails.
We don't unfortunately. YT make a set, otherwise, you can make your own from a set of VS ecotec billet fuel rails as shown in the link below: http://esprit.gatewaybbs.com.au/~vrtidy/modifying_the_v...
-
Would BORED OUT AND POLISHED THROTTLE BODY! Holden VN-VY suit a VS V8 1995 manual, and not increase idle rpm above 1000?
This would suit your VS V8. Given the tight tolerances of our re-manufactured throttle bodies, factory idle speed is maintained. Idle speed will not increase with installing one of our throttl...
-
Would cam packages be suitable for a VE SV6 fitted with a Raptor Supercharger engine?
Given that you’re planning on running the Raptor Supercharger head unit, which is limited to how much boost it can run, I would say not to worry about the cams. If you were staying NA, then most ce...
-
Would COLD AIR INTAKE TO SUIT HOLDEN VR-VS V8 fit my VS series III Ute with VT roller cam motor?
Unfortunately, this product will not suit the Series 3 VS Commodore. In saying this though, it should be possible to modify the piping between the throttle body and the pod filter adaptor tube to f...
-
Would HIGH RATIO ROLLER ROCKERS TO SUIT HOLDEN VS-VY V6 fit on a 2000 VT V6 Ecotech engine?
Yes, they would.
-
Would I be able to use the plenum spacer along with the manifold spacer? What gains can I expect If I use both?
Yes, you would be. Torque down low would increase by 13%-15% depending on the spacer combination used.
-
Would I be able to install the cams into a raptor charged Ute (175kw, manual) then drive it to my tuner to adjust my tune?
Given the custom engine you are running, your best bet would be to allow a experienced mechanic to install and adjust the cam to suit your custom engine. However we do provide instructions on insta...
-
Would I be able to run the LS1 throttle?
No, you would need a custom dyno tune.
-
Would I benefit from a dyno tune once you guys have done the Power Pro Flash tune?
If you get logs of the car on the dyno with our Power Pro Flash tuning service, we could further refine the tune for you.
-
Would I need a tune after installing 25mm manifold insulator, 12mm plenum spacer and a cold air intake for a VY series 2?
The tune is not required.