Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
I was just wondering if you sell twin throttle body manifolds for VY V6 Ecotec?
Unfortunately we no longer manufacture these due to lack of demand. We have also found that you can get approx 90% of the gains of the twin TB manifold by fitting our manifold and plenum spacers co...
-
I was looking around ebay for a SS inductions growler kit for my VT, and I am sure you know they are like $450-$500 which is ridiculous.
They are more expensive then our intake, at this point in time.
-
I was looking around the website and noticed the crow cams for higher ratios. What kind of power figures would you expect (normally) compared to stock? Which would you recommend, stock rollers with stage 2 comp or stage 2 crow with current yella tera rock
Power output with this combination would be very similar to that of the stage 2 comp cam coupled with the factory ratio rockers. I would advise the stage 2 comp cam with standard rockers as we woul...
-
I was looking at Mace's cometic head gaskets are they ok to just fit back onto the head without machining head?
Assuming that the cylinder head and engine block surfaces are still within spec, and copper coat is applied to all of the mating surfaces, then it won't be a problem.
-
I was looking at buying some engine upgrades for my VY V6 Commodore Ute and I was wondering about Mace's Cold Air Intake, why do yours not hurt the MAF sensor?
Our CAI kit does not hurt the MAF, due to the fact that the filter supplied in the kit is an oilless. This basically means that our air intake kit cannot contaminate the MAF with oil, insuring that...
-
I was looking at Mace's stage 3 stroker kits and H beam con rods and would like an idea of HP rating.
The Stage 3 stroker kits in the links below can reliably take around 500rwhp (400rwkw). http://www.maceengineering.com.au/epages/shop.sf/en_AU/?ObjectPath=/Shops/mace/Products/STRK601/SubProducts/...
-
I was looking at one of your performance memcals for my VS commodore Ute, but I can’t find a memcal to suit a VS series 3, can you please advise?
For answering these types of questions we would require more information like:-Is that for a V6 or V8 engine?
-
I was looking at the Mace cold air intake manifold insulator for the VZ Alloytec V6 and was just wondering of the two types you have which one is a better purchase for power gain? I would say the 20mm manifold?
In regards to power production in the lower RPM range (where they need assistance most, due to their short inlet manifold runners), the 25mmm item would be the better of the two. Otherwise if you t...
-
I was looking on your website at the L67 water to air intercoolers and noticed in one of the pics(the red VT/VX) there was different L67 fuel rails than stock (billet fuel rails). Do u sell these if so how much?
Unfortunately, we don't sell fuel rails at this point in time. In saying this though, you can have a go at making a setup yourself based on the instructions in the link below: http://esprit.gatewa...
-
I was looking the Mace cold air intake manifold insulator for the VZ Alloytec V6 and wanted to ask when installing this, is it a straight unbolt, place the manifold and then re-bolt up with longer bolts? With nothing extra needed.
Besides tools for the job, this is correct. For more information about the process, please check out the fitting instructions in the link below: http://www.maceengineering.com.au/WebRoot/ecshared0...