Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
When installing the 25MM COLD AIR INTAKE MANIFOLD INSULATOR TO SUIT ALLOYTEC VZ-VE 3.6L V6, should I also buy new manifold gaskets? What would you recommend?
We would recommend installing the manifold insulator kit using our supplied silicone sealant, without any gaskets. To give you an idea as to the installation process, please refer to the fitting in...
-
When installing the12mm PLENUM/MANIFOLD SPACER do you have to bleed the air out of engine or anything?
There is no need to bleed the air out when installing the plenum spacer.
-
When it comes to installing the VE Manifold insulators, are the two electrical harnesses to be removed the ones to the manifold runner solenoid and the EVAP solenoid?
Where applicable, this is correct.
-
When obtaining a motor is the only other item I need a ECU? Are the ones Mace offer suitable?
You can use your current ecotec wiring loom (though requiring slight modification), and a revised memcal (VS-VT models) or a revised PCM (VX-VY models) to suit. In regards to a suitable memcal or P...
-
Where does the in/outlets for the water to go through for the L67 mini blizzard intercooler plate? Could i possibly get a few pictures?
They go through the side of the plate. For further details, please refer to the fitting instructions in the link below: http://www.maceengineering.com.au/WebRoot/ecshared01/Shops/mace/4FFA/23AB/F4B...
-
Where would I get a balanced flywheel for my VY Ute to suit the L67 engine as I’m doing a L67 engine conversion?
You would need to take the original flex plate and your flywheel to an engine shop so that they can mirror/match balance the flywheel to the original flex plate.
-
Which is the best way for MLS EXHAUST MANIFOLD GASKETS HSV LS1 LS2 LS3 LS7 LS9 LSA S/C 5.7L 6.0 6.2 7.0 V8 to be fitted?
Basically, you need to make sure that the mating surfaces are cleaned before fitting the gaskets, which can be done with a non-abrasive Scotch-Brite pad. If sealing has been an issue, you can ...
-
Which is the better Plenum spacer, 12mm or the 24mm?
The 12mm plenum spacers are recommended for naturally aspirated (NA) applications, while the 25mm plenum spacers are recommended for supercharged/turbocharged applications.
-
Which is the faster combination overall for my VY L67? (Combo 1-4.5 sec with traction issues fixed in a lighter weight VS, or is this too optimistic?)
About 4.5-5 sec per 0-100km/h.
-
Which is the faster combination overall for my VY L67? Combo 2: (Not sure how much faster this setup would be)
About the 4.5 sec mark give or take a little.