Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
What would Mace advice I should get next for my Holden VS Ecotec V6. So far it has 2.5in cat back exhaust, mace cold air intake, stage 2 shift kit with corvette servo and a tune. I was thinking a 12 or 25mm manifold spacer or throttle body. What would I g
In regards to gains, you would achieve greater gains down low (at lower engine speeds) with the manifold insulators, while the throttle body would mainly improve gains top end. In saying this about...
-
What would Mace recommend as the easiest/cost effective way to increase torque? I tow a 4.5M tinny (boat), and would like to get better fuel consumption on my VZ Alloytec V6.
While we have many performance products to suit the Alloytec, given your torque requirements, our manifold insulators would arguably be your best choice. For more information about these available ...
-
What would the gains for the Alloytec manifold insulatons be for the 12mm and 25mm versions?
In regards to gains you, would be looking at around 10% and 13% improvement in torque down low for each respectively.
-
What would the max boost you can run with ported charger and inlet manifold and 25mm spacer plate with a custom tune?
The max boost that you'll be able to run is approximately 14 to 15 psi.
-
What would the price be for the cold air intake to suit holden VB-VL V6 product no (CAI607) (Including pipe work and filter)?
You're looking at $250 plus $22 postage.
-
What would Mace recommend with the 3 stage cam kit to get the most out of my Ecotec engine also thinking of running 18 or 19 psi on a super charger?
You may consider the following parts which will give you a better performance: Comp Cams: http://www.maceengineering.com.au/epages/shop.sf/en_AU/?ObjectPath=/Shops/mace/Products/CAM604/SubProduct...
-
What's the compression height of MACE FLAT TOP PISTON SET HOLDEN COMMODORE UTE VG VP VR VS 304 5.0L V8?
These have a compression height of 1.710 inches.
-
What's the difference between your 12mm plenum spacer and 25mm plenum spacer? And what is the difference between the 12mm and 25mm manifold insulators as well?
The 25mm plenum spacer is designed for blown applications, for N/A applications we find the 25mm plenum spacer reduces throttle response to much and therefore recommend the 12mm spacer instead. It...
-
What's the difference between your two eBay ads? For roller rockers for a ecotec. One has in title high ratio roller rockers and the other is ultra high ratio roller rockers, there is about a 150 dollar difference.
Please note that Ultra high ratio roller rockers 1.98:1 ratio provide more lift and hence more power gains over the high ratio roller rockers 1.9:1 ratio, Moreover, you may find the complete detail...
-
What's the power difference between the 25mm and the 12mm?
There is about 3-4% difference in down low torque.