Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
Just a question what would you suggest is better/reliable or which one will get more power out ofthe INTERMEDIATE INTERCOOLER KIT HOLDEN SUPERCHARGED 6 L67 or the MACE Engineering complete A2A intercooler kit? Also when installing one of these kits is the
In regards to the power output between the intermediate W2A and A2A kits they're about the same, however, the A2A one has greater potential with higher-end mods (larger supercharger, etc.) In regar...
-
Just a quick inquiry about the pulley removal tool. I purchased the tool to upgrade to the 11 psi pulley and all went brilliantly - I am very happy with the result and ease of use. My only question is whether the tool can be used to replace the original p
We are glad that your happy with the tool. The tool can be used to replace the original press on pulley.
-
Just a quick question in regards to my VX L67 AUTO ...mods are CAI and 10psi pulley When I go down hills or rolling with foot not on accelerator I get rev pulsating of about 200-500rpm .. I don't think its a blow headgasket as the oil is clean the radiato
How old are your O2 sensors? The reason I ask is that it's very likely that the car is going into close loop (basically relying on the O2 sensors for fuel metering) under these conditions. As soon ...
-
Just another question, will the stage 2 CROW CAMS TO SUIT V6'S WITH HIGHER RATIO ROCKERS have a lumpy idle?
The S2 cam to suit the rockers will certainly give you a lumpy idle.
-
Just bought a VY L67 over the weekend if I were to get a bigger throttle body down the road would this require a tune?
We do recommend that you do the tune and TB at the same time.
-
Just did an IC install on my Factory Supercharged V6 (L67) and have an oil leak which looks like it's coming from the back of drives side. Possibly from the lim gaskets. I replaced old oem gaskets with Aluminium Inlet manifold gaskets. Car hasn't gone any
You can reuse your current gasket, however you would need to apply sealant on the mating surfaces just to make sure that it's sealed properly.
-
Just inquiring about Mace's 1.9.1 ratio rockers,stage 2 cam and memcal package for VS getrag do these two products work in conjunction with each other?
Assuming you're referring to our COMP Cam and tune package, then we would not recommend a set of 1.9:1 ratio rockers with this cam as it would cause engine damage. If you're referring to the CROW C...
-
Just inquiring about TCM and speedometer tuning. I already have a remote tune done, but I don’t want to get the ECM reflashed, but just the TCM.Is that possible?
We can do this, no problem.
-
Just received my CAI box. Thanks for the prompt delivery. Should I be concerned that is has VL-VS V6 written all over it when I ordered VR-VS V8?
No need to be concerned as the box is identical for both V6 and V8 variants.
-
Just wanted some info about the 1.9:1 high ratio roller rockers, 5/16" push rods (required on VY models). Do I need to buy any other modifications for these to work efficiently or can they be bought by themselves?
No other modifications are required for these items to work effectively, you just bolt these in and drive. If you have any other questions please do not hesitate to ask.Kindest Regards, Steve