Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
What is the price on the high ratio rocker arms to suit my 6 liter VZ?
The price for the rocker's arms is shown in the link below: http://www.maceengineering.com.au/epages/shop.sf/en_AU/?ObjectID=1469549
-
what is the safe rockers to put with the stage 3 MACE PERFORMANCE CAMSHAFT HOLDEN COMMODORE VS VT VX VU VY ECOTEC 3.8L V6?
The standard rockers are more than capable with this cam.
-
What is the seat pressure and Open pressure of your valve springs to suit Buick SPG609?
The details can be shown below: Seat pressure: 116LB @ 1.7" Open pressure: 310LB @ 0.5"
-
What is the Size of MACE VITON VALVE STEM SEAL SET FOR HOLDEN COMMODORE VS VT VU VX VY ECOTEC L36 L67 S/C 3.8L V6? (SPG605)
The size of valve stem seals is 7.3 x 11.5mm.
-
What is the size of the bolts come with MACE 12mm Performance Manifold Insulator kit to suit Holden Ecotec L36 3.8L V6 (95-00)?
With the exception of the 4 M6 screws, all of the hardware that we supply in the bolt packs of our kits need to be custom made to be able to install the insulator.
-
What is the size of the Hi flow pod filter for MACE cold air intake kit to suit Holden commodore ECOTEC L36 L67 S/C 3.8L V6?
These run a 6-inch long pod filter, with a 3-inch intake opening, like the factory piping. To give you a better idea in regards to the size of the filter, please refer to the fitting instructions ...
-
What is the smallest pulley can put on a standard statesman WH 2000 model?
Assuming your car is in good working order, then the smallest pulley you can run is a 3.4 inch pulley (10psi) on 98 octane fuel. If you're running 95 octane fuel, then the smallest you can run...
-
What is the standard boost on a VX Calais and what can a stock motor handle safely?
The standard boost pressure on a VX Calais L67 is 6psi, while they can comfortably take around 10psi on a standard engine/tune running 98 octane fuel. With a tune and intercooler (depending on the ...
-
What is the thickness of MACE MLS HEAD GASKETS HOLDEN ECOTEC L36 L67 SUPERCHARGED 3.8L V6? In MM not inches?
They are 1.295mm and 1.6mm for GSK606 and GSK608 respectively.
-
What is the torque setting to torque MACE MLS head gasket to suit VS VT VU ECOTEC L36 3.8L V6 with ARP head studs?
Please torque the heads/gaskets up to the ARP stud specifications.