Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
Is there a big difference between your 12mm and 25mm manifold spacers for Alloytec VE? Will it fit my car g8?
The 12mm and 25mm manifold insulators for the Alloytec (LY7) engine, increase torque by 10% and 13% respectively. If you tend to spend most of your time in the mid to top end range or low to mid ra...
-
Is there a difference in V6 ecotec insulators between the VS-VT one an the VX-VY one?
There is. Please refer to the product descriptions and respective part numbers below: COLD AIR INTAKE 12MM MANIFOLD INSULATOR 4 HOLDEN VS-VY Part Numbers - MI601 (VS-VT ecotec V6) - MI602 (VX-VY ec...
-
Is there a generic tune for a standard vs eco with 2 1/2 cat back or just generic, with cai, and custom tune? If not, I'll certainly be looking at getting the standard memcal.
We do have a number of tunes to suit vehicles with various bolt on modifications such as the ones you have suggested. hese memcals are not standard but performance tunes. You will need to notify us...
-
Is there a MAF less tune available for my Alloytec/LY7 V6?
Unfortunately, it's not possible to have a MAFless tune done with the factory engine management system on a Alloytec.
-
Is there a parameter you could adjust to give a nice burble upon throttle liftoff?
We will have to talk to the tuner about tuning engine over run. A decent high flow exhaust with good quality "straight flow" type mufflers will also help with this.
-
Is there an after market intake manifold for a V6 SIDI (LF1, LFW, LLT, LFX) engine?
There isn't an aftermarket manifold to suit at the moment. In saying this though, you can port your current manifold for additional gains.
-
Is there any certification for the modifications, that if it is taken to a holden workshop for installation the new car warranty will not be voided?
We don’t have such certification, however your best bet would to contact Holden direct.
-
Is there any conflict with the OEM hood using the 12mm Plenum Spacer with the insulator in the 2010 Camaro V6?
There would be no conflict with the OEM hood using the 12mm plenum spacer and 25mm manifold insulator provided the engine cover is not installed.
-
Is there any difference other than 13mm difference between the 12mm plenum spacer and the 25mm plenum spacer? What would be more suitable for a 3.8L VS Ute?
The difference between the two plenum spacers is that the thicker one offers greater air distribution between cylinders, however, this is at the expense of throttle response. This isn't a problem w...
-
Is there any high ratio rockers that would work with Stage 2 COMP Cams on a VS V6?
In regards to higher ratio rockers for our range of COMP Cams to suit ecotec and L67 engines, we generally don't recommend them. However, if you were trying to squeeze as much power out of your bui...