Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
In regards to these relatively new cam packages for the VZ-VE Alloytec engines, would it be safe to assume reasonably versatile performance for street driving in general?
If would, admittedly though they start making power at around the 2.5-3k mark.
-
In regards to these relatively new cam packages for the VZ-VE Alloytec engines, what kind of labor/engine work is involved in the installation and a rough idea of what it might cost to have it done?
With the right tools (which we now have to loan out for free), you can replace the cams without taking the front engine cover off which is around 4-5 labor. If the front engine cover has to come of...
-
In regards to your NA mods for my car (according redbook) does 0-100 in 9.3 secs. If I did some modifications like roller rocks, CAI and re-calibrated computer, how much would that improve?
You would be looking at a reduction of approximately 1 second off your 0 to 100km/h time. These items are certainly compatible with LPG, including the spacers.
-
In relation to the VE MACE SIDI OTR, is it essential that we get a tune? Will it be fine to postpone for a few months or would I be better off doing the entire package together?
Ideally it would be good to get a tune done at the same time. In saying this though no fault codes should come up with our OTR.Though if you're on a budget and have a manual VE V6, then it should n...
-
In the website at memcals, is there a generic tune for a standard VS ecotec with 2 1/2 cat back or just generic, with cold air intake and custom tune?And what is the price of the same?
We do have a number of tunes to suit vehicles with various bolt-on modifications such as the ones you have suggested. You're looking at $145 for the memcal plus $15 postage?
-
In your advertisement you have said that power gains of about 30rwkw can be achieved with this alloytec cam package in conjuction with a tune. Is that correct?
This is correct.
-
Is "PERFORMANCE PLENUM SPACER for FORD BOSS 260-290-315 V8 5.4L" the top spacer that goes between the top plenum chamber and intake or does it go between lower intake manifold and head?
This item for auction is the top spacer that goes between the top plenum chamber and the intake. The lower intake manifold insulator (between the intake manifold and cylinder heads) is available se...
-
Is a gasket required on both sides of MACE 6.35MM SUPERCHARGER INSULATOR HOLDEN COMMODORE VS VT VX VY L67 S/C 3.8L V6?
They can be installed with gaskets on each side of the insulator, however, they can also be installed directly without any gaskets if used with silicone sealant.
-
Is a North American plant that you work with as well?
There are a number of workshop in the US that we work with, however we’re based in Australia.
-
Is a ported manifold going to be released for V6 SIDI engines like the alloytecs?
Possibly in future, however there are no plans for this at this point in time.