Michael
- Total activity 4127
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2167
Articles
Recent activity by Michael-
I want to purchase the BOSCH 36LB/H INJECTORS for a supercharged V6. Do you sell these injectors separately or do I have to buy all six? If so, whats the best deal you can do on a whole new set?
We don't sell these separately, as they're flow benched in lots of six. Your looking at $250 delivered.
-
I want to replace my inlet manifold gasket on my L67. I am aware I need a supercharger gasket and o rings, but do I need and head gasket as well?
These are not required to be replaced when changing your inlet manifold gaskets on your L67.
-
I want to turbo my L67 engine. So can i just change the intake manifold or do I need to put the Ecotec heads too?
You can just change your intake manifold and block off the injector port in the intake manifold or cylinder heads. Please note when doing this that these holes are blocked off properly such that th...
-
I wanted to confirm if I could fit a MACE/VCM OTR to my LFX engine? I had the OTR on my 2011 VE SV6 LLT Engine but I understand the radiator mounts have changed on the LFX.
If you have a MY07 to MY11 VE Commodore VCM OTR it will not fit MY12 or newer VE Commodores. The main reason for this is that the radiator assembly MY12-onwards VE Commodores is different to the ea...
-
I wanted to convert my Ecotec engine into L67, so I could essentially get an L67 and bolt it up to the same mounts as my ecotec?
Correct.
-
I was advised to use 105 lbs springs as I am looking to use the Mace COMP Cam with 1.8 rockers and stock valve springs, but that means I have to remove my balance shaft which I don’t like as I'm sure the engineers at GM put it there for a reason.
They did; to counteract secondary harmonics at around 1500RPM. This tends to be insignificant as soon as a decent sized cam is installed.
-
I was advised to use 105lbs springs as I am looking to usethe Mace COMPCam with 1.8 rockers and stock valve springs, but that means I have to remove my balance shaft and run a double roller. I've heard a few horror stories of people using 105lbs springs w
If people make sure that they use the right retainers for the job with the 105lb springs (insuring an installed pressure of 105 lbs), then the tensioner seems to last. Ideally though going a double...
-
I was considering installing your 1.9 rockers but it seems that they only perform above 3000 rpm, I very rarely go above 2500 rpm unless on the open road and over taking so would it be beneficial for me. Please advise?
While the rockers do predominately increase mid to top end power, they also improve part throttle driveability at lower engine speeds, making the car more responsive.
-
I was doing a 4:11 locked rear end and full exhaust on my VS V6 do you think the Stage 3 Comp Cam package would be suitable ?
Definitely.
-
I was interested in a tune for a Holden cruze 1.4 turbo sedan 6sp manual. I have done up an custom intercooler kit and 2.5' turbo back exhaust with a cold air intake system.could I get a quote for a tune?Will it still be good on fuel as the customer doesn
We can definitely help you out. Our tune will take these modifications into account further improving drivability and power. The remote custom tune normal price is $550 we can offer it to you for $...