Jason
- Total activity 4130
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 2198
Activity overview
Latest activity by Jason-
Jason commented,
Hi Shannen,I hope all is well on your end :)Unfortunately, we don't do installations, however, the fitting instructions have been sent to your email address, please have a look when you can.Kind Re...
-
Jason created an article,
Will It Fit/ How Will It Fit Under The Bonnet?
Your best bet would be to take a couple of measurements just to make sure, as every car is different but here is a fitment summary from experience shown below: Raising manifold by 12mm:...
-
Jason created an article,
Will I Need New Push Rods?
No you don't unless you have a VY model. Unfortunately, Holden got a bit slack with there casting maintenance when they knew the production run was coming to an end. This resulted in excessive ca...
-
Jason created an article,
Can You Supply A Tune For The V6 Throttle Bodies?
Yes we can - we can supply a MEMCAL or Computer Tune (depending on the year of your commodore) to suit the throttle body.
-
Jason created an article,
In Regards To The Plenum Spacer, What Do You Mean By Boost Application?
We mean for either turbo or supercharged applications.
-
Jason created an article,
Can You Supply A Tune To Suit The A2A (Air to Air Intercooler) Kit?
Unfortunately we can't - you will need to get the car dyno tuned.
-
Jason created an article,
What The Maximum Amount Of Boost You Can Run On A Standard Engine?
If your car is dead standard the max you can run is 10psi (3.4") - in conjunction with 98 octane fuel. On 95 octane fuel the max you can run is an 8psi (3.6") pulley. With the addition of an interc...
-
Jason created an article,
Will I Need A Tune To Run The MAF?
You'll definitely need a custom tune done for it to work.
-
Jason created an article,
Which spacers/Insulators For Ecotec ?
For N/A (naturally aspirated) applications we recommend the 25mm manifold spacer and 12mm plenum spacer. If you are running boost we recommend a 25mm plenum spacer and 12mm manifold spacer, as th...
-
Jason created an article,
What Is The Smallest Pulley I Can Run Until The Supercharger Snout Needs Turning Down?
The 15 PSI (2.9") pulley is the smallest pulley you can run without having to machine down the end of the snout - to run our 16,17 or 19 PSI pulleys you will need to machine down the snout. We ha...