Siya
- Total activity 2783
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 1360
Articles
Recent activity by Siya-
Would Cold Air Intake to Suit VY Ecotec & L67 fit a VY with Ecotec S1 with factory gas?
Yes it will.
-
Would HIGH RATIO ROLLER ROCKERS TO SUIT HOLDEN VS-VY V6 fit on a 2000 VT V6 Ecotech engine?
Yes.They would
-
How long should I let the sealant set for before driving my car?
Silicone dries in 1 hour, and fully cure in 24 hours. Your can can be driven after one hour of installation or 4-5 hours in supercharged or turbocharged applications. Allow more time in cold or ver...
-
Would I need any gaskets for COLD AIR INTAKE MANIFOLD INSULATOR 12MM HOLDEN VS VT VX VU VY ECOTEC V6?
Given the gasket like properties that the insulator material has, no additional gaskets are required. However, silicone sealant is required to be used, which is included in the kit at no extra cost.
-
Would it be an issue if I reused the stock bolts? Please suggest
Assuming that the bolts haven't stretched (experienced necking), as per the diagram below, then they'll be fine to reuse: http://repairguide.autozone.com/znetrgs/repair_guide_content/en_us/images/0...
-
Which tools are needed to install a manifold insulator?
You can complete the installation using Allen keys, a socket set, a screwdriver, and pliers. We also recommend using engine degreaser to clean the intake manifold, especially around the injectors i...
-
Would it worth getting a better intake kit and K&N Filter along with the tune or this would not make much of a difference?
It would help, the tune represents the best value for money upgrade for these vehicles.
-
If you want it to take off quicker then a set of manifold insulators, higher diff gear ratio, air intake upgrade and tune would certainly help out.
Once all bolts are removed, the manifold can be lifted off without damaging the insulators. However, be careful not to bend the manifold insulator during removal, as excessive bending may cause it ...
-
Would like to know if that complete A2A intercooler for 2150 is NSW legal?
We're not 100% sure, due to the changes in legislation in NSW recently. However assume that it isn’t, pending approval from a suitably certified automotive/transport engineer.
-
Would SV6 VE VF ORSSOM OTR cold air intake SIDI LFX LLT 3.6 3.0 V6 suit 2012 VE dedicated gas?
Yes, it will, there shouldn't be any issue.