Knowledgebase: GENERAL ENQUIRIES
Do you have to change the pushrods when installing rockers? I heard that for VX’s you don’t have to but for VY’s you do?
Posted by MACE Support on 30 April 2018 09:05 AM
With the 1.9:1 ratio rockers, what you've mentioned is correct. However if you wanted to install a set of 1.98:1 ratio rockers on a VX then you would require pushrods, which already come in the kit. You cannot easily install the 1.98:1 ratio rockers for the reasons shown in the link  below http://support.maceengineering.com.au/Knowledgebase/Article/View/35/0/why-are-the-ultra-high-rockers-not-suited-to-vys

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: