Knowledgebase: GENERAL ENQUIRIES
We have attempted to install a new pulley using oyurpulley removal/instaltion tool. In doing so by mistake we have driven the pulley on too far, to the point where the tool plate does not fit behind the pulley to draw it back. Does Mace have another plat
Posted by MACE Support on 30 April 2018 08:24 AM
In this situation we would suggest that you fabricate a plate the screws into place of the pulley. This would then easily allow you to use our pulley removal/installation tool for the job. Otherwise the snout would have to come off and a press used to adjust the position of the hub

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments: